OHC head studs
Posted: Sun May 04, 2025 10:44 am
I just received a set of new studs from Ian Harris, for the spare engine I'm building for the '29 tourer. The set of ten come with two small sleeves which fit in place of the two stepped studs on the original engines, making the stud manufacture simpler, while offering the opportunity to leave them off if it is necessary to move the head slightly to align the vertical drive.
If you are in need, you can contact Ian at ianhms@outlook.com
If you need HTS head nuts, I'd recommend LAS Aerospace - https://www.lasaero.com/products/article/X03A5OVA3
You need to order A27-EP nuts. (These are also good for the SV heads.)
If you are in need, you can contact Ian at ianhms@outlook.com
If you need HTS head nuts, I'd recommend LAS Aerospace - https://www.lasaero.com/products/article/X03A5OVA3
You need to order A27-EP nuts. (These are also good for the SV heads.)