Cable layout
Posted: Wed Jun 23, 2021 4:07 am
I would like to know where / how various cables etc are located in a 1930 OHC Minor.
Speedo cable: How does it get from parallel to ground at the gearbox to vertical at the speedo without getting mixed up with pedals, wiring etc?
Battery cables to engine earth and starter switch. I am thinking of running the +ve cable alongside the transmission tunnel. An aside from that: Is the floorboard supported in any way on the inboard (trans tunnel) edge?
Fuel pipe: From tank to carb, does it go through the firewall or under it somewhere sort of above the starter?
Where on the firewall were the cutout/fuse box and ignition coil placed, And was the coil horizontal or vertical?
Did the HT leads from distributor to coil and plugs just dangle in the air or were they gathered in some kind of holder?
Any pics, sketches or just words would be appreciated.
Speedo cable: How does it get from parallel to ground at the gearbox to vertical at the speedo without getting mixed up with pedals, wiring etc?
Battery cables to engine earth and starter switch. I am thinking of running the +ve cable alongside the transmission tunnel. An aside from that: Is the floorboard supported in any way on the inboard (trans tunnel) edge?
Fuel pipe: From tank to carb, does it go through the firewall or under it somewhere sort of above the starter?
Where on the firewall were the cutout/fuse box and ignition coil placed, And was the coil horizontal or vertical?
Did the HT leads from distributor to coil and plugs just dangle in the air or were they gathered in some kind of holder?
Any pics, sketches or just words would be appreciated.